LG WF-T1480TD - Page 41

4) Water doesn’t come into the wash tub.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Inlet V
alve
1. If water doesn’t come though the
inlet valve works(electric sound
occurs)
1) Check whether water mains is cut.
2) Check whether tabs are turned on.
3) HOT & COLD tab are opposite
connected.
4) Wrongly select
Water Temperature option.
5) If there are no problems in the
above, check the inlet valve lters
after disconnecting the water supply
hoses.
6) If there are no problems in the
above a diaphragm hole in the valve
is blocked by foreign substance or
the plunger in it is locked.
2. If the inlet valve doesn’t work(there
is no electric sound)during lling
cycle.
1) Check whether it’s connectors are
taken o or they have poor
connection.
2) Check resistance of the inlet valve.
Water mains cut.
Don’t tumed on.
Connected
opposite.
Selected
opposite.
Filters blocked
by foreign
substance.
A connector is
taken o.
Mains cut.
Mistake of use.
Wrong installation.
Mistake of use.
Don’t clean.
Defect of the
inlet valve.
Defect of contact.
Coil is open
Explain.
Turn on the tap.
Correct their locations
and turn on the tap.
Explain how to use.
Clean them by brush
and explain cleaning
regulary them.
Change the inlet valve.
Reconnect it or remove
the causes to make poor
connection.
Change the inlet valve.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Drain Motor
1. Operate washer setting spin only,
then press the START/PAUSE button
when the wash motor starts to work
and then press the START/PAUSE
button again in order for the drain
motor to work intermittently.
Contr
oller
1. If mains voltage and the drain motor
have no defects a defect of the
controller is highly possible.
Reset happens
after the drain
motor works.
Defect of the drain
motor (A noise
generated when the
internal relay
works.)
Change the drain motor
Change the controller.
3) Reset during operation
41