WATER
TEMP
WATER
LEVEL
WASH
POWER
DELAY
START
HOT COLD
WARM
ORMAL
ENTLE
TRONG
INLET Er.
DRAIN Er.
DOOR Er.
SPIN Er.
SOAK
WASH
SPRAY
RINSE
SPIN
DELAY
TIME
LEFT
LEVEL
EX-LARGE
LARGE
MEDIUM
SMALL
WATER-DETERGENT
NORMAL
DELICATE
SPEEDY
WOOL
JEAN
FAVOURITE
START
PAUSE
PROGRAM
AUTO OFF
MTM
RINSE
SPIN
WASH
S
N
G
HOW TO USE
DELAYED WASHING
HOW TO
SELECT TEMP.
HOW TO ADJUST
THE WATER LEVEL
FOR MANUAL WASH,
RINSE AND SPIN
DISPLAY ABNORMAL
OPERATION
HOW TO SELECT A
WASHING PROGRAM
WASH PROCESS DISPLAY
●
Upon loading laundry,
it displays the correct
amount of detergent
to be added according
to the amount of laun-
dry(based on concen-
trated detergent).
●
Use this function for
delayed washing.
●
Use it to set the delay
time.
●
By pressing the but-
ton, it cycles [3 → 4 →
5 → ... → 11 → 12 →
14 → 16 → ... → 46 →
48 → 3] hours.
(Up to 48 hours can
be delayed).
●
To cancel delay time,
turn the power switch
off.
●
Used to select proper
water temperature of
washing water.
[WARM(Hot and cold
light turn on) → HOT
→ COLD → WARM]
mode repeats.
●
By pressing the button, it cycles [LARGE
→ LARGE ¥ EX-LARGE → EX-LARGE →
SMALL → SMALL ¥ MEDIUM → ME-
DIUM → MEDIUM ¥ LARGE → LARGE]
●
At NORMAL and JEAN program, water
level is selected automatically based on
the amount of laundry.
●
Water level is set to LARGE for WOOL
and DELICATE program.
●
Water level is set to MEDIUM for SPEE-
DY program.
●
Water level can be adjusted even when
the washer is in operation.
CHILD LOCK
●
Used to lock or unlock the control but-
tons to prevent all the the setting from
being changed by a child
●
For locking, push both buttons simulta-
neously and for unlocking, push them
one more in washing process.
START AND TEMPORARY PAUSE
●
Use it to start or pause temporarily.
●
Pressing the button repeats start and
temporary pause.
●
After 10 minutes in a temporary pause
state, the power will automatically turn off.
●
Indicates the current washing status.
●
Next step is lit, current step blinks
and finished step is turned off.
In contents of display part the
meanings of M, T, M are min-
utes, times and minutes.
●
In case of abnormal operation, the following
indications are displayed.
Abnormal water supply : INLET Er. lamp blinks.
Abnormal drainage : DRAIN Er. lamp blinks.
Abnormal spin : SPIN Er. lamp blinks.
Abnormal water level sensing :
displayed.
Abnormal lid open : DOOR Er. lamp blinks.
●
Use it to select washing programs.
●
By pressing the button, it cycles
[NORMAL
→
DELICATE
→
SPEEDY
→
JEAN
→
WOOL
→
FAVOURITE
→
NORMAL]
●
Wash:
Use it to change washing time.
By pressing the button [21min → 25min
→ 40min → 60min → 90min → OFF →
3min → 6min → 9min → 12min → 15min
→ 18min → 21min] SOAKING is used to
remove old or hardened dirt more
effectively.
Soaking time is about 40, 60, 90minutes
(You cannot choose in WOOL and
DELICATE program.).
●
Rinse:
Spray rinse/Deep 1 is preset in the
NORMAL wash program.
[Spray rinse + Deep 1 → Deep 1 →
Spray rinse + Deep 2 → Deep 2 → Off →
Spray rinse + Deep 1] mode repeats.
Use it to change the frequency of rinses.
By pressing the button are repeated.
When you select rinse only, the
operation starts with water supply.
●
Spin:
Use it to change the spinning time.
By pressing the button, [6min → 8min →
OFF → 1min → 2min → 4min → 6min].
●
Use it to adjust the
strength of water current.
●
By pressing the button, it
cycles [ → → ]
●
Strength of the water cur-
rent can be adjusted at
any course.
At the beginning, it starts
with MED [ ].
DETERGENT DEPOSIT
DISPLAY
WASH POWER
NOTE
S
S
GN
●
The Normal program is used for average day to
day washing.
●
Press POWER ON button.
●
Load clothes.
●
Add detergent, bleach and conditioner as desired.
●
Close the lid and press START/PAUSE button.
●
The water level lights will scroll up and down while
the washer is working out the optimum water level
for your clothes load.
● Check if laundry is washable in
water.
● Be sure to remove things such
as keys, pins and coins from the
laundry.
● Wash oily or dyed laundry
separately.
● Shake loose dirt off before
washing.
● Wash fluffy laundry by turning
it inside out.
● Wash delicate clothes,
wrapping them in a nylon net.
●
Other programmes are selected as follows.
●
Press POWER ON button.
●
Load clothes.
●
Add detergent, bleach and conditioner as desired.
●
Select temperature, level, process, program and options as described below.
●
Close the lid and press START/PAUSE button.
3) WF-T802, T852
❏
Fully automatic control
❏
Manual control
❏
Preparation before wash
Sort your washing into separate wash loads
●
Each load of washing should contain clothing which needs the same
washing conditions. For example, you should not wash delicate
clothes with very dirty work clothes.
●
Some fabrics are lint collectors and can pick up lint,dirt and colour
from other fabrics, which are lint producers. Some examples are
listed below.
LINT COLLECTORS LINT PRODUCERS
Corduroy Towels
Synthetics Nappies
Permanent press fabrics Chenille / Candlewick
Make sure that you wash lint collectors separately from lint producers.
To Next Page
Loading...
