26 27
●
The Normal program is used for average day to
day washing.
●
Press POWER ON button.
●
Load clothes.
●
Add detergent, bleach and conditioner as desired.
●
Close the lid and press START/PAUSE button.
●
The water level lights will scroll up and down while
the washer is working out the optimum water level
for your clothes load.
●
Other programmes are selected as follows.
●
Press POWER ON button.
●
Load clothes.
●
Add detergent, bleach and conditioner as desired.
●
Select temperature, level, process, program and options as described below.
●
Close the lid and press START/PAUSE button.
3) WF-T902, T852
❏
Fully automatic control
❏
Manual control
HOW TO USE
DELAYED WASHING
●
Use this function for
delayed washing.
●
Use it to set the delay
time.
●
By pressing the button,
it cycles [3 → 4 → 5 →
... → 11 → 12 → 14 →
16 → ... → 46 → 48 → 3]
hours. (Up to 48 hours
can be delayed).
●
To cancel delay time,
turn the power switch off.
❈
Except for WOOL and
DELICATE program.
HOW TO
SELECT TEMP.
●
Used to select proper
water temperature of
washing water.
[WARM(Hot and cold
light turn on) → HOT
→ COLD → WARM]
mode repeats.
STAIN LEVEL
SELECT
●
Default is MEDIUM.
By pressing
button [HEAVY
LIGHT MEDIUM
mode repeats.
●
Available during
washing.
❈
Except for WOOL and
DELICATE program.
●
Pressing the FA-
VOURITE button al-
lows you to store your
favourite wash condi-
tions in the NORMAL
cycle memory and
than recall it for use at
a later time.
FAVOURITE SELECT
Preparation before wash
Sort your washing into separate wash loads
●
Each load of washing should contain clothing which needs the same
washing conditions. For example, you should not wash delicate
clothes with very dirty work clothes.
●
Some fabrics are lint collectors and can pick up lint, dirt and colour
from other fabrics, which are lint producers. Some examples are
listed below.
LINT COLLECTORS LINT PRODUCERS
Corduroy Towels
Synthetics Nappies
Permanent press fabrics Chenille / Candlewick
Make sure that you wash lint collectors separately from lint producers.
●
Check if laundry is washable in
water.
●
Be sure to remove things such
as keys, pins and coins from the
laundry.
●
Wash oily or dyed laundry
separately.
●
Shake loose dirt off before
washing.
●
Wash uffy laundry by turning
it inside out.
●
Wash delicate clothes,
wrapping them in a nylon net.
HOW TO ADJUST
THE WATER LEVEL
●
By pressing the button, it cycles [LARGE
→ LARGE ¥ EX-LARGE → EX-LARGE →
SMALL → SMALL ¥ MEDIUM → ME-
DIUM → MEDIUM ¥ LARGE → LARGE]
●
At FUZZY and JEAN program, water
level is selected automatically based on
the amount of laundry.
●
Water level is set to LARGE for WOOL
and DELICATE program.
●
Water level is set to MEDIUM for SPEE-
DY program.
●
Water level can be adjusted even when
the washer is in operation.
●
For appropriate guantity of detergent
follow the detergent manufacturer’s
instruction
CHILD LOCK
●
Used to lock or unlock the control but-
tons to prevent all the setting from being
changed by a child
●
For locking, push both buttons simulta-
neously and for unlocking, push them
once more during the washing process.
START AND TEMPORARY PAUSE
●
Use it to start or pause.
By pressing the button [Start
Pause]
are repeated.
POWER
●
Use it turn on and off. By pressing
the button [
On
→
Off
]
are repeated.
●
Electric power automatically
turns off in 10sec, after the
washing cycle finishes with "boo-"
sound.
●
Electric power automatically
turns off after 10min.in ’Parse’
condition
HOW TO SELECT A
WASHING PROGRAM
●
Use it to select washing programs.
●
By pressing the button, it cycles
[NORMAL
→
SPEEDY
→
JEAN
→
DELICATE
→
WOOL
→
NORMAL]
FOR MANUAL WASH,
RINSE AND SPIN
●
Wash:
Use it to change washing time.
By pressing the button [21min → SOAK
5min → SOAK 10min → SOAK 15min →
SOAK 21min → OFF → 5min → 10min
→ 15min] SOAK is used to remove old
or hardened dirt more effectively.
Soak time is about 60minutes (You
cannot choose in WOOL program.)
●
Rinse:
Use it to change the frequency or rinse.
By pressing the button.
[rinse 1 → rinse 2 → rinse 3 → rinse 4 →
OFF → rinse 1] are repeated.
When you select rinse only, the
operation starts with water supply.
●
Spin:
Use it to change the spinning time.
By pressing the button, [5min → 7min →
OFF → 1min → 3min → 5min].
DISPLAY ABNORMAL
OPERATION
●
In case of abnormal operation, the following
indications are displayed.
Abnormal water supply : NO INLET. lamp blinks.
Abnormal drainage : NO DRAIN. lamp blinks.
Abnormal spin : displayed.
Abnormal water level sensing :
displayed.
Abnormal lid open : DOOR OPEN. lamp blinks.
PE
UE
To Next Page
Loading...
