46
▶ Be sure to unplug the power to repair and replace
electric parts.
10-1. Replacement of Controller Part
WF-T851, T902
1.Disassemble inlet valve ring.
2. Loosen the two screws on the back side and
disassemble back panel(joined control panel) from
top cover.
WF-T853, T852, T802, T652, T652A, T452
WF-T452A , 402
1.Disassemble the two screw caps in the front of
washing machine using sharp tool, and loosen the two
special screws. Push the panel to left side then pull
out.
2. Use boxer if special screw head is worn out.
WF-T851, T902
▶ Take off all controller connectors and loosen four
fixing screws to remove the controller from the
right panel.
WF-T853, T852, T802, T652, T652A, T452
WF-T452A, 402
▶ Take off all controller connectors and loosen four
fixing screws to remove the controller from the right
panel.
10. DISASSEMBLY AND FUSE REPLACEMENT
Fig.1
Fig.2
Fig.3
Be sure to make earth connection for trouble
diagnosis and parts replacement. If impossible, touch
earth wire on the body to remove electric deviation
between the body and product before work.
CAUTION FOR ELECTROSTATICS
To Next Page
Loading...
