10-2. Disassembling of Top Cover
▶ Loosen the two front special screws and the two
fixing screws in the back side(Fig.4) and
disassemble top cover from washing machine.
10-3. Replacement of Tub Parts
▶ As in Fig.6, disassemble top cover and loosen the
5 screws on tub cover.
▶ Take out pulsator cam assembly with "─" type
driver. Loosen pulsator fixing screw and lift
the pulsator.
1. As in Fig.7, take out pulsator cam assembly with
"─" type driver and disassemble pulsator. Unscrew
one pulsator washer, one hub fixing nut and then
one hub spring washer. Pull up washing/dry tub.
2. To disassemble clutch, loosen four fixing bolts
below tub with washing machine slopped.
In disassembling pulsator, be careful not to fall
the washer below pulsator into washing/dry tub.
LOC.No.;A180
CAUTION
Tub cover
Fig.4
Fig.5
Fig.6
Fig.7
To Next Page
Loading...
