Fig.8
Fig.9
Fig.10
Fig.11
10-4. Replacement of Outcase and
Suspension Asm
▶ Open the back cover on the back of machine and
disassemble all lead wires.
(Pull out the pressure switch tube and connector
housing.)
▶ Separate top cover from washing machine.
▶ As in Fig.10, lift snubber bar and take it out of
out case with out tub.
▶ Damper assembly shall not be disassembled.
Replace damper as assembly.
▶ For assembly, refer to Fig.10.
WF-T851, T902, T853, T852, T802, T652, T652A
WF-T452, T452A, 402
▶ Disassemble base by loosening the fixing screws
on the bottom side of base and replace the
Class LOC. No. PIVOT(Color)
, K102 Blue
, K101 Natural
※ SVC should be replaced as damper set.
A B
C D
Class LOC. No. PIVOT(Color)
, K101 Natural
, K102 Blue
※ SVC should be replaced as damper set.
A D
C B
To Next Page
Loading...
