21
5
6
3
6 74
6 7
4 6 7
4
6 7
4
Close the lid Finish Caution & Note
•
The pulsator rotates for
8 seconds to detect the
laundry load.
•
Then the WATER
LEVEL and the amount
of Detergent to be
used will be shown and
water will be supplied.
•
Water will be
supplied for 2
minutes after the
start of the wash to
supplement the
water the laundry
has absorbed.
•
When the wash
program ends, the
buzzer will ring for
10 seconds before
the Power goes
off automatically.
• If water is already in the tub, or putting
wet laundry into the tub before starting will
increase the WATER LEVEL.
• With lightweight bulky loads, WATER
LEVEL can be set low.
•
When setting the WATER LEVEL manually,
do not set to Medium to prevent damage to
laundry.
• Washing with HOT water may damage the
laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.
• In order to avoid damage to laundry, the
spin cycle may appear slow. This also
avoids wrinkles and clothing may still
contain some water. This is normal.
• When static pressure of water is more
than 2kg/cm
2
, the QUICK WASH course
will be within 19min.
To Next Page
Loading...
Need help?
General
