If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or “ ” error can happen to it.
It must be placed on a firm and level floor to prevent spin failure.
26
Installation
P
lacing and Leveling
Caution
Top view of the machine
more than 10 cm
more
than
2 cm
more than
2 cm
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the
right side and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is
suggested.
Check that the machine is level
Open the lid and look from above to see if it is
same as shown.
Leveling the machine
Lift the front of the washing machine and twist
the Adjustable Leg until the surface bubble is
placed in the center.
If the power is supplied from a cord extension set or generator, the cord extension set or
electrical portable outlet device should be positioned so that it is not exposed to splashing or
ingress of moisture.
1
2
3
Please ensure that transit restraint has been removed before operating your machine.
NOTE
Adjustable legs
Level indicator
To Next Page
Loading...
Need help?
General
