29
Installation
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
packing within the hose can adhere completely to
the tap.
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then
tighten it by screwing it to the right.
Check water leakage.
After connecting the hose, open the tap to check
for any water leakage.
• Connect the water supply hose to inlet valve of
the washing machine, and then lock it by turning
the hose connecting part.
• Check to see if there is a rubber seal inside the
connector.
Screw Type
Water Supply Hose
Rubber Packing
Hose connector
Rubber seal
Water
tap
Connecting Water Supply Hose to the machine
1
2
3
• purchase the water supply hose for extension at the LG
electronics agent or service center.
Using the connector of the water supply hose , connect
it to the water supply hose. (commercial item)
• When either of cold or hot water supply hoses is used,
you can connect the hose which is not used to the
connector of the water supply hose .
When the water supply hose is to be extended (Option)
Warning : Please don ’t connect the hot water only.
To Next Page
Loading...
Need help?
General
