HOW TO USE THE WASHER
OPTION
CHILD LOCK
DOOR LOCKED
16
• Use this option for loads that need pretreatment. Adds
16 minutes prewash and a spin cycle.
1. Prewash
• Displays whenever the door of the washer is locked.
• The door can be unlocked by pressing the
Start/Pause button to stop the washer.
NOTE: If the water temperature or the level is too high, the
door cannot be unlocked.
Do not try to force the door open when
is displayed.
STATUS INDICATOR
• It shows elapsed time of the cycle the washer is
operating.
EST. TIME REMAINING
• This display shows the estimated time remaining
in the cycle when operating.
• This washer automatically detects the wash load
(weight) and optimizes the washing time. After
detecting, the display will show the adjusted time
remaining.
• Use this option to prevent unwanted use of the washer.
Press and hold PRE WASH button for 3 seconds to
lock/unlock control.
• When Child lock is set, “ ” blinks and all buttons are
disabled except the Power button. You can lock the
washer while it is operating.
• Adds more time to the wash and rinse cycles for better
stain removal.
• Automatically provides a rinse.
4. Stain cycle
• Adds extra water to the wash and rinse cycles for
superior results.
5. Water Plus
• The Drum Light comes on when the Power button is
pressed. It goes off when the door is closed and the
washer starts operation.
• The Drum Light remains off when the door is locked.
• The Drum Light can be turned on while the washer is in
operation by pressing the Rinse+Spin button for 3
seconds. The light will turn off automatically 4 minutes
later.
• The Drum Light comes on when the washing cycle is
finished and goes off 4 minutes later.
6. Drum Light
• Spin Sense
TM
‚ can be used where the floor is
wooden or when you worry about a vibration.
• Push Stain cycle button for 3 sec to operate Spin
Sense
TM
‚ cycle when any cycle is processing that you
has chosen.
• One of the buttons that you has chosen spin speed on
the Spin Speed Button line light comes on and out
continually when Spin Sense
TM
‚ Cycle was selected.
Push Stain Cycle button for 3sec again to cancel Spin
Sense
TM
‚ cycle.
• If the Spin Sense
TM
‚ cycle was selected onetime, the
Spin Sense
TM
‚ Cycle will be continually application
during spin even the power goes out and come again.
7. Spin Sense
TM
• This option provides an additional rinse.
• Use this option to ensure the removal of detergent or
bleach residue from garments.
3. Extra Rinse
• Use this option to rinse and then spin.
2. Rinse+Spin
To Next Page
Loading...
