19
5
6
3
6 74
6 7
4 6 7
4
6 7
4
Close the lid Finish Caution & Note
•
The pulsator rotates for
8 seconds to detect the
laundry load.
•
Then the WATER
LEVEL and the amount
of Detergent to be
used will be shown and
water will be supplied.
•
Water will be let in
again 2 minutes
after the wash has
started to
supplement the
water the laundry
has absorbed.
•
When the wash
program ends, the
chime will sound
for 10 seconds
before the Power
goes off goes off
automatically.
• If water is already in the tub, or putting
wet laundry into the tub before starting will
increase the WATER LEVEL.
• With lightweight bulky loads, WATER
LEVEL can be set low.
• Changes to Water Temperature
(HOT/COLD) and wash level are possible
during operation.
(refer to page 14)
•
When setting the WATER LEVEL manually,
do not set below level number 6 in order to
prevent damage to the woollen clothes.
•
Washing with HOT water may damage the
laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.
•
In order to avoid damage to laundry, the
spin cycle may appear slow.
This also avoids wrinkles and clothing may
still contain some water. This is normal.
• When static pressure of water is more
than 2kg/cm
2
, the QUICK WASH course
will be within 19min.
To Next Page
Loading...
