LG WT-H9556 - Service Manual

Other manuals for LG WT-H9556

Questions and Answers:

A
Adam PearsonJul 31, 2025
What to do if my LG WT-H9556 Washer is not draining?
- J
  Jamie SilvaJul 31, 2025
  If your LG Washer is not draining properly, it might be due to several reasons. First, check if the drain hose is correctly positioned, ensuring it's hung up at a height of 0.9 to 1.3 meters for models with a pump, or placed lower for non-pump models. Also, make sure the drain hose isn't folded, clogged, or frozen. If these steps don't resolve the issue, the drain motor might be faulty, or the WHITE(WH) 2 pin connector to the P.W.B ASM may have a bad connection, requiring you to replace the drain motor or correct the connector contact.
K
Kristie ChenAug 5, 2025
Why is my LG WT-H9556 not draining?
- K
  Katrina MontgomeryAug 5, 2025
  If your LG washer isn't draining, several factors could be at play. First, verify that the drain hose is correctly positioned and not bent or placed too high. Also, check the internal part of the hose or drain pump for any clogs caused by impurities. Finally, ensure that there isn't a power outage.
N
Noah LangAug 10, 2025
Why is my LG WT-H9556 Washer vibrating and not spinning?
- T
  Travis GoldenAug 10, 2025
  If your LG washer is experiencing spin failure or seems unbalanced, start by checking if the laundry load is evenly distributed inside the drum. Also, make sure the washing machine is placed on a flat, level surface. Using too much soap can also cause this issue.
A
annperezAug 15, 2025
Why is my LG WT-H9556 Washer not getting water?
- H
  halesusanAug 15, 2025
  If your LG Washer isn't getting water, start by checking if the water faucet is fully open. Ensure that the water supply hasn't been interrupted. If the water supply is fine, the inlet valve might be clogged with dirt; in this case, clean or replace the filter. Also, check the connector to ensure it has good contact with the inlet valve. Similarly, inspect the Yellow(YL) 2 pin connector for good contact with the P.W.B ASM and correct if necessary.
C
Carol MurphyAug 20, 2025
How to fix an unbalanced LG Washer?
- J
  jvargasAug 20, 2025
  If your LG Washer is experiencing an unbalance issue, it might be because the laundry inside the inner tub is not distributed evenly; try to rearrange the items for a more uniform fill. Another potential cause is that the washer itself is not level; adjust the legs to ensure it stands correctly. Additionally, the S.F S/W might be too close to the washing tub or have a bad contact, requiring a check and possible replacement. Finally, inspect the CONNECTOR of the Ball pressure sensor for disconnection or poor contact; check or replace the B.P sensor if needed.
M
Mark LamAug 26, 2025
What to do if my LG Washer water supply isn't working?
- J
  Joshua FisherAug 26, 2025
  If your LG washer isn't getting water, there are several things to inspect: * Ensure the water tap is fully open. * Confirm that the water supply hasn't been cut off. * Check for freezing in the tap or water supply hose. * Examine the water pressure and inlet valve filter for clogs. * Verify the drain hose isn't elevated above 90cm as per the installation guidelines. * Make sure the hot and cold hoses are connected correctly to their respective inlets. If the Washing Machine is subjected to an unstable supply of water, 'IE' is on the DISPLAY.