Hose Hanger W/Storage Compartment
Owner’s Manual
Model #501
™
b a sic s
VISIT OUR WEBSITE: WWW.LIBERTYGARDENPRODUCTS.COM
OR CALL US TOLL FREE AT 1-866-820-5805
LIBERTY GARDEN PRODUCTS, INC.
1161 SOUTH PARK DRIVE, KERNERSVILLE, NC 27284
TOOLS REQUIRED:
Stud
Finder
Hammer
Drill
Electric
Drill
Flat head
screwdriver
or bit for an
electric drill
1.Using a stud finder, locate wood studs on your wall.
2. Position and hold hose reel (A) against the wall, mark
the position of each suspension hole and remove the reel
from the wall.
INSTALLATION:
3. Using an electric drill, drill (6) pilot holes 1/4” in diameter
at the marked positions on the wall.
5. If Plastic wall anchors (BB) are required, drill (6) 5/16”
diameter pilot holes at the marked positions on the drywall
or masonite and insert all (6) wall anchors (BB).
6. Using a screw driver, insert the top (3) wood screws
(AA), or optional masonry screws half way into the top (3)
pilot holes or wall anchors (BB).
7. Mount hose reel (A) on the top (3) screws.
8. Install the bottom (3) wood screws (AA) or masonry
screws and tighten all (6) screws. Do not overtighten
the screws.
4. For optional brick or masonry screws, use a hammer drill
to drill (6) 1/4” pilot holes at the marked positions.
A
A
AA
BB
AA
Holds 125 ft. of 5/8” Hose
To Next Page
Need help?
General
