Troubleshooting Guide
Owner’s Manual
Liberty
ANCHOR Audio, Inc. (310) 784-2300
100-0005-000 / Revision F, 03/97
Having trouble with the sound system?
Condition Possible Cause
No sound (power LED not lit):
• power switch OFF
• batteries fully discharged (LED flashes briefly)
Charge indicator doesn’t light: • blown fuse
No sound
(power LED lights): • no output from source
• input cable unplugged
• input volume control low or off
• plug inserted into switched speaker output,
but no speaker connected
Shortened battery life: • short in external speaker cable or speaker
• total external speaker impedance < 4Ω
• batteries not fully charged
• batteries need replacement
Distorted sound: • poor connection on input cable
• input signal too strong
Excessive hum or noise: • input cable not shielded
• not using balanced microphone
Having trouble with the wireless system?
Condition Possible Cause
No sound (TX ON indicator lights): • mute switch set to ‘mute’ position
• wireless volume control low or off
• no mic plugged into belt-pack transmitter
No sound
(TX ON indicator off): • sound system not turned on
• transmitter power switch turned off
• low battery or no battery in transmitter
To Next Page
General