Your browser will now load a special
SAFELERT Setup Web Page.
Follow the onscreen instructions to
complete your SAFELERT Sensor setup.
6
Open an internet browser on your
computer, smartphone or tablet.
In the address bar type: 10.5.5.2 and press
Enter or Go.
5
It may show you an error indicating that
you do not have an internet connection.
This is normal.
Tip
Go to the wireless (Wi-Fi) settings of
your computer, smartphone or tablet.
Search for available wireless networks
and connect to the Wi-Fi network named Elertus.
4
The Elertus Wi-Fi network cannot provide an
internet connection, but will provide access to
the SAFELERT setup web page.
Setup
page
Wi-Fi
Wi-Fi
When the LED light on your SAFELERT
Sensor is flashing YELLOW it is in a
special setup mode. You can connect
to it just like you would your home or business
Wi-Fi network.
3
Wi-Fi
Wi-Fi
Ensure that Wi-Fi is enabled on your computer,
smartphone or tablet, then continue.
Press and hold the little, white button
on the front of your SAFELERT Sensor
until the LED light flashes YELLOW.
2
You may need to hold the button down for
up to 15 seconds. The LED may blink other
colors before it begins flashing YELLOW.
Tip
Install the batteries into your
SAFELERT Sensor, and wait for the
LED light to turn solid RED.
1
A slot on the left side of the SAFELERT Sensor enables
you to pry the case open using a flathead screwdriver.
Tip
Before You Begin,
You Will Need
Your Liberty SAFELERT Sensor and the
included AA batteries.
A computer, smartphone or tablet with
Wi-Fi capability.
A flat-head screwdriver.
Your wireless (Wi-Fi) network name and
password. To make the setup easier, write
them in the space below:
Network Name: __________________________
Password: ________________________________
SAFELERT Setup Guide
POWERED BY
To Next Page
Need help?
General