40
rotation), Time Scheduling and Antilegionella.
6.2.1 SET
It is the temperature at which the water is adjusted
in the Hot Water output (or maintained in the tank),
permanently in manual or only in automatic in
the periods of comfort. Range 0÷99C°, with limits
depending on UC, by increments of 1°C (default 50°C).
6.2.2 TIME SCHEDULING
It contains the timely programming window through
which it is possible to dene a weekly time program
for the Hot Water (it can be enabled setting the
Automatic program at page Mode).
It is possible to set up to 4 time slots, by increasing
of 15min, for single day (Mon, Tue, …) o for interval
(Mon-Fri, Sat-Sun, …).
The page is divided in two parts (picture 11), in the
upper one, turning the knob, it is possible to select
days or intervals, in the lower one the period of
Comfort (On). After selecting one day/interval, by
pushing the knob, it is possible to modify the time
slots. Turning the knob the start/end interval value
changes, while pressing data are conrmed going to
the following variable. Once ended the modications
end, by pressing Conrm, what has been done is
saved, by pressing Cancel, the modications are
ignored. In any case, after conrming or cancelling,
you will return to the selection of a new day or new
interval (default from Monday to Sunday, 06:00 -
23:00, -, -, -).
6.2.3 ANTILEGIONELLA
It takes the Hot water set at 65°C for 2 minutes,
with priority to other programs, checking continually
the achievement of this temperature level within a
maximum time of 60 minutes.
Entering the Antilegionella page, it can be set up
one time and one day for the function intervention.
If the set up day is “none”, the function is disabled.
However, it is always deactivated during the
Holidays program, in OFF status when the Hot
Water program is in Standby.
6.3 HEATING SETTINGS
The Menu of Heating Settings is the most complex and
it includes the Adjustment parameters and the power
graphics settings.
picture 11
To Next Page
Loading...