SPIRAL MIXER RESIDUAL RISKS
The machine highlights the risks that were not fully eliminated during the design phase or when the suitable safety devices were
installed.
In order for the customer to be fully informed of the machine’s residual risks, those that are ever-present have been listed below:
these actions are considered incorrect and are therefore strictly prohibited.
A sound power of less than
or equal to 70 dB, produced
when the machine is in
operation.
If the environment is particularly noisy, wear
appropriate protective equipment to protect
your hearing (headphones).
The operator may slip if the
floor is wet or dirty.
Use the appropriate anti-slip personal
protective equipment when using the
appliance.
Keep the area in front of the oven clean.
The staff can crush their
fingers or hand in moving
parts.
Maintenance must only be carried out by
qualified personnel wearing personal
protective equipment (gloves).
Cutting injuries can occur
when coming into contact
with the machine frame’s
internal components during
maintenance work.
Maintenance must only be carried out by
qualified personnel wearing personal
protective equipment
(cut-resistant gloves and clothing that covers
the forearms).
Moving the appliance or part
of it without suitable
equipment.
Use suitable lifting systems or accessories
when handling the appliance or its packaging.
(See chapter 4: INSTALLATION)
Electric shocks
(Electrocution)
Coming into contact with live
electrical components during
maintenance work that is
carried out when the electric
panel is live. The operator
carries out the work (with an
electric tool or without
disconnecting the machine’s
power supply) whilst laying
on a wet floor.
Appliance maintenance must only be carried
out by qualified personnel wearing electric
shock-resistant personal protective
equipment.
Electrocution caused by the
earthing system or electrical
protective devices
malfunctioning.
Install protective devices that conform with
the current regulatory requirements,
upstream of the appliance.
During the dry ingredient
loading operations, airborne
dust may be produced.
Minimise the loading height in the bowl.
Use protective equipment to protect the
respiratory tract and eyes
(mask and glasses).
Hygienic and
microbiological
Caused by the machine and
its installation site being
inadequately cleaned.
Poor hygiene can pose a risk to human
health.
Pay special attention to the cleaning cycles.
Fixed guards or safety
devices being removed.
Under no circumstances should the operator
remove the fixed guards (panels) or safety
devices (bowl grid, micro grid and bowl
sensor).
To Next Page
Loading...
