22
Maintenance
Remove the car seat from the car before carrying out any
maintenance work. The seat can be cleaned with soap and
lukewarm water. Do not use any abrasive detergents. The belt
buckle can be cleaned using warm water. Do not lubricate. The
cover must be washed by hand (maximum 30° C). Do not use
a dryer (also see washing instructions). IMPORTANT! Never
remove the energy absorbing foam.
Tip: It is advisable to buy an extra cover when purchasing the our
baby car seat, so that you can continue using it even when the
cover is being washed or dried.
Removing the cover
1. Remove shoulder harness.
2. Slide seat pad from car seat by gently pulling it off the top of
car seat back.
Retting the cover
1. To ret the cover, carry out the above instructions in reverse
order.
2. Make sure that the lower section of the cover aps over the
uppersection.
3. Fasten the adjustment strap under the shell again.
Waste seperation
To ensure optimum and safe use of car safety seats, they should
not be used for longer than 5 years after the date of purchase.
Ageing of the plastic, for instance under the inuence of sunlight
(UV), may quite unnoticeably reduce the qualities of the product.
Once the child has grown out of the seat, we therefore advise
you to no longer use the car seat and to dispose of it in the
proper way. As we care for the environment we request the user
to separate the waste produced at the start (packaging)and end
(product parts) of the life of the baby car seat.
To Next Page
Loading...