a)
Foam
filter
element:
clean with
home
detergents and
warm water
(or
non-flammable
or high flash-point
cleansing solvents
)
and
dry
up, then soak
in clean engine
oil until saturated.
Squeeze out excess oil,
otherwise,
the engine
will discharge smoke in starting stage.
::
b) Paper filter
element:
knock the core against a
solid
plane
to
got
rid of accumulated
dust or blow out dust
from
inside
to outside
with high-pressure air flow
(not
more
than 30psi). Never clean
with a brush, as
brushing
may
force
the dust into the core fiber. If
the core
is
extremely filthy, replace
with a new one.
2.
Clean the dust-collecting
hood: screw off the three
special semi-round
screw
and
remove the hood,
wash
parts
with water
and then
dry up. Reinstall the hood.
CAUTION:
a
When
reinstalling
the
dust collecting core air
cleaner, make sure to
embed
the
fin on the
pre-air
cleaner hood
in the
dent in the
dust- collecting hood.
O
Install
the air
guide
in
correct order.
Single-core type
1.
Remove
the wing nut
and air cleaner housing,
and take
out the filter element.
2.
Clean with home
detergents
(or
high flash-point
cleansing solvents) and
wam wateq and dry up.
3. Soak n clean
engine
oil until saturated;
squeeze oil, or the engine
will exhaust smokp in
starting stage.
4.
Reinstall
the filter element
and air cleaner
housing.
25
To Next Page
Loading...