Lifan M13E - Page 29

Oil
bath
type
L
Remove the nut and air cleaner
housing, and
take out the filter
element.
2.
Clean
with home detergents
(or
high flash-point cleansing
solvents) and
warm water, and dry
up.
3. Soak in
clean engine oil until
saturated.
Squeeze excess oil,
or the
engine
will discharge smoke in starting
stage.
4. Empty the air
cleaner housing of
oil. Clear away the
dust in
side
with non-flammable or
high flash-point cleansing
solvents,
and
dry it up.
5. Fill the
air
cleaner
housing
with the specified engine
oil up to
the
standard oil level
mark.
6.
Reinstall
the
air cleaner
Oil capacity: 1.1L.
\ryASHING OF
DEPOSIT CUP
Set the fuel cock
at " OFF
",
disconnect the
deposit cup and
O-ring.
Wash in non-flammable
or high flash-point
cleansing
solvents, and then try them
up, at last,
reinstall it.
Set
the
fuel
cock
to
"
ON "and
check
for leaks.
Ait
housing
;Foarn
Air clesner
housing
Foam
Foxm
26
,mark