EasyManua.ls Logo

lifefactory 4oz User Manual

lifefactory 4oz
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EN
General Care:
• Before first use, place glass bottle and silicone nipple or valve in
boiling water for 3 minutes to ensure cleanliness. Please note that
silicone valves are only included in sippy caps.
Use caution when boiling the glass bottle and silicone nipple or
valve as the boiling water and steam may cause severe skin burns.
Before first use and as soon as possible after each use, wash all
parts with warm, soapy water. Rinse all parts thoroughly and
allow time to dry.
To allow venting and prevent nipple/valve collapse, do not
over-tighten lid when reassembling product.
For sippy caps only, before first use, pinch the tip of the silicone valve. Control silicone valve flow rate by tightening
or loosening cap. Valve in sippy cap is removable for fastest flow.
Contents should not be left in the container for longer than 24 hours. As soon as possible after each and every use,
wash all parts with warm soapy water. Rinse all parts thoroughly with clean water. Allow all parts to dry completely
prior to next use or storage.
DO NOT use abrasive cleaners or scrubbers since they may scratch or chip the glass.
DO NOT use bleach or cleaners containing chlorine on any parts of the product.
This product is top-rack dishwasher safe; however, hand washing is recommended as the dishwasher uses harsher
detergents and hot water that may aect the appearance of your product.
4oz & 9oz Glass Baby Bottle
CARE AND USE GUIDE
Question and Answer IconNeed help?

Do you have a question about the lifefactory 4oz and is the answer not in the manual?

lifefactory 4oz Specifications

General IconGeneral
Brandlifefactory
Model4oz
CategoryKitchen Appliances
LanguageEnglish

Summary

General Care and Cleaning

Initial Cleaning and Sterilization

Boil glass bottle and silicone nipple or valve for 3 minutes before first use for cleanliness.

Routine Washing and Drying

Wash all parts with warm, soapy water after each use, rinse thoroughly, and allow to dry.

Sippy Cap Valve Operation

Pinch sippy cap valve tip before first use; control flow rate by tightening or loosening the cap.

Washing Method Recommendations

Hand washing is recommended over dishwasher use to preserve product appearance.

Assembly and Usage Instructions

Replacing the Silicone Sleeve

Detailed steps for safely removing and replacing the silicone sleeve on the glass bottle.

Important Safety Warnings

Do not leave children unattended, prop bottles, or use nipples as pacifiers.

Usage Precautions and Warnings

Nipple and Valve Care

Avoid prolonged exposure of nipples/valves to sunlight, heat, or sterilization fluid.

Glass Bottle Safety

Check for cracks before each use; avoid extreme temperature changes and stovetop use.

Liquid Contents Handling

Do not overfill, avoid carbonated drinks, and exercise caution with spoilage.

Limited Warranty Information

Warranty Coverage

One-year warranty against defects in material or workmanship, excluding normal wear and tear.

Warranty Service and Contact

Instructions for sending defective units for repair or replacement to Thermos L.L.C.