Lifesaver 5CO - Installation Instructions - Mounting

9
5. Installaon Instrucons – Mounng
THIS ALARM MUST BE INSTALLED BY A COMPETENT PERSON AND IS TO BE INSTALLED
ACCORDING TO THESE INSTRUCTIONS
Wall-mounng (recommended by the manufacturer, if possible)
1. Drill two holes in a wall 7.8 cm apart (you may wish to use the back-plate for
guidance)
2. Insert the two rawl-plugs, that are supplied, into the holes
3. Insert the two screws as supplied into the holes ensuring enough of the screw scks
out of the wall (approx. 3mm)
4. Hook the alarm over the screws
Free-standing
ALWAYS BE CAREFUL TO LOCATE A FREE-STANDING ALARM WHERE IT IS UNLIKELY TO BE
KNOCKED TO THE FLOOR, AND IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS -
RECOMMENDED LOCATIONS SECTION.
Ensure free-standing alarms are placed in the upright posion, and not lying flat on a surface.
2532-7205-04_V2:_ 2016.1.14 2:38 PM Page 9