Quick User Guide
INSTRUCTIONS
This quick user guide should be used in conjuction with the
Instruction Manual provided with your LIFESAVER
®
jerrycan.
FIRST USE
1
Priming - Unscrew and remove pump from the
LIFESAVER
®
jerrycan. Fill with tap water, camp water
or water from any clean source. Screw pump firmly
back into place. Let stand for 5 minutes.
ROUTINE USE
1
Caution! - When filling the LIFESAVER
®
jerrycan with
water take care to keep the tap area clear. Do not
unscrew tap in the field.
5
Operation & Storage - Your LIFESAVER
®
jerrycan
will work in any orientation. As the water gets low
changing the orientation will improve the flow rate.
Protect from freezing and shocks.
2
Filling - Unscrew and remove pump. Fill with water
from tap, camp, river, lake, stream or other source.
Use the cleanest water source available. This will
prolong the life of your LIFESAVER
®
jerrycan.
3
Pumping - Turn tap off. Twist pump handle to unlock
and pump a few times. Twist pump handle to lock
closed.
4
Drinking - Turn tap to open postion and clean sterile
drinking water will flow. Pump again to improve flow.
Turn tap off.
2
Pump & Discard - Turn tap to open position. Untwist
pump handle and pump untill water starts to flow.
Discard first 2 litres. Your LIFESAVER
®
jerrycan is
ready to use.
© 2007-2013 LIFESAVER
®
Systems. All rights reserved. Patents and registered designs pending and
granted. LIFESAVER
®
is a registered trade mark. The following are trademarks of the LIFESAVER
®
group
of companies:- FOR A HOSTILE WORLD™, FILL.PUMP.DRINK™, FAILSAFE™
To Next Page
Need help?
General
