SPECIFICATIONS
Base Unit
Input Power: 12~15V DC, 300mA /400mA.
Standby Current: 60-90mA. (depends on the receiver type and rechargeable battery).
RF : (Follows local regulations, other frequencies as requested)
Frequency: 433 MHz
Data Modulation: OOK.
Power: less than 10mW.
Range: about 200ft or more @open field, 25℃.
Receiver Type: super heterodyne.
RF Security Code: 16,777,216 combinations with check sum for each type of sensors.
More than 4 billion combinations in total.
Dialing Type: Pulse/Tone selectable.
Preset Telephone Number: 10 phone numbers, one pager, 2 CMS data links.
Voice Recording: 120 seconds in total.
Emergency announcement in 6 segments, 13 seconds for common segment, 4 seconds
each for Panic, Burglar, Fire, Medical, Special and Latchkey segments.
Event Log: max. 512 records.
Display: 3 LEDs, 2x16 LCD panel in blue color with backlight.
Sensor Zones: total 288 zones. (Burglar zones x 128, Fire zones x 64, Controller zones x 32,
Medical zones x 32, Special sensor zones x 32)
Wire Sensor Input: total 3 sensors.
Memory Back-up Time: min. 3 months after power break.
Battery Back Up Operation Time: about 6-15 hours. (depending on back up battery type, only for
the Base Unit)
Password: 14 passwords each with max. 8 digits.
Alarm Out: 230V AC /3A rate relay contacts or 12V DC/200mA output.
Delay Activation Time: 0- 255 seconds programmable.
Switch Control Interface: 16 units of X-10 switches.
Digital Interfaces: RS-232 (9600/ 8 bits/no parity/stop bit) or 10M/100M Ethernet (optional),
RS-485 (reserved).
Remote Display Memory: 32 characters/set, total 10 sets.
Internal Siren: 110dB at 30cm distance.
CMS protocol: Contact ID.
Clock Accuracy: within 5 seconds daily.
Telephone Line Cut Detection Voltage: 20V+/- 4V. (this function may not be used in some countries.)
Operation Temp.: -10℃~40℃.
Storage Temp.: -20℃~55℃.
Humidity: 10-95%RH.
Size: 248x180x52 mm.
Weight: about 950 g.
(The manufacturer reserves the right to change the specifications without prior notice)
35
To Next Page