32
PREMIER 2250 S&E SERIES SPECIFICATIONS
For ¾”, 1” and 1¼” Water Mains
Rating: ANSI/NSF 42 rated at 3,535,000 gallons for aesthetic chlorine removal. While
testing was performed under laboratory conditions, actual performance may vary.
Statement for claims: This system has been tested according to NSF/ANSI 42 for
reduction of chlorine. The concentration of the indicated substance in water entering the
system was reduced to a concentration less than equal to the permissible limit for water
leaving the system, as specified in NSF/ANSI 42. This was verified and substantiated by
test data.
Flow rate: Tested & certified at 10 g.p.m.
Regulated pressure: Min.—40psi, Max.—100psi
Dimensions: Diameter: 13”, Height: 62.5”
Temperature: System should not be operated with
an influent water temperature in excess of 140°F. In
geographic areas where outside temperatures are
less than 32°F for an extended period of time,
insulation is required.
Power requirement: 1 standard 110v electrical outlet
within 5’ of system or a 24v transformer plugged into
a more distant electrical outlet.
Backwash: ½” PVC to drain/irrigation which must
accommodate 7g.p.m. for a short period of time.
Installation space required: 27” width X 66” height.
Pressure drop: 4psi
Note #1: Do not use with water that is
microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system.
Note #2: See Installation Instructions for user
responsibility, general operation and maintenance
requirements, service to the system and parts and
service availability.
To Next Page
Loading...
