8
Step 1: Remove Packaging
(Fig 1)
1. Flatten the shipping box and
remove all packing materials
and parts.
Step 2: Assemble Handlebars
(Fig 2)
1. Remove Bolts (12) and (25) with
Washers (26) from the treadmill.
2. Carefully lift the Support Handles
up to their operating position.
Check the wire harness at the
bottom pivot point to make sure
it runs inside the frame and does
not get in the way as the Support
Posts are lifted.
Note: Please be very careful not to
pinch the wire harnesses where
the Base Frame and Support
Handles meet.
3. Re-install Bolts (12) and (25)
and Washers (26) using the 6mm
Allen Wrench for bolt (12) and the
5mm Allen Wrench for bolt (25).
Do not completely tighten these
bolts until the end of Step 3.
4. Install screw (13) thru the
handlebars and into the handlebar
supports using the provided 5mm
Allen wrench.
Note: Please be careful not to
damage the wires running inside
the handlebars that are used by
the grip pulse and toggle switches.
Step 3: Assemble Safety Bar
(Fig 3)
1. Install the Safety Bar onto the
Support Posts using screw (14)
and the 5mm Allen wrench found
in your hardware bag.
2. Securely tighten screws (12), (13),
(14) and (25).
Step 1
Step 2
Step 3
To Next Page
Loading...
Need help?
General
