LifeSpan TR800 - Page 44

Press and Hold STOP and then Speed Up buttons
until the console beeps and the display changes.
Press Enter / Mode (TR1200i only)
Guard automatically pauses the unit if it detects the
treadmill is not being walked on. Use Up Down buttons
100
ROL
599
44
Engineering Mode
Press Enter / Mode to show Roller diameter
TR800: roller diameter in inch
TR1200i: roller diameter in mm
Press Enter / Mode to set up the units of measurement
in Metric (SI) or in English (EN).
Press Speed/Incline or Up/Down to change
Press Enter / Mode
for Distance
This is the total distance the treadmill has been run
in Miles or Kilometers depending on what mode the
treadmill is in.
Press Enter / Mode for Workout Time
This is the total number of hours the treadmill
has been used.
Press Enter/Mode again to return to the standby mode.
En or Si
Press Enter / Mode to set up Calendar
Calendar Operation:
(incline window shows software version)
(lower right corner shows software version date)
2009.07.09
Press STOP and then SPEED UP to enter the Engineering Mode. You can press ENTER/MODE to
switch setup screens, or press STOP+SPEED UP to return to Standby Mode. The table below
shows the sequence of the setup screens.
Information on screen
Engineering function
On
I - G
CALE
NDER
On
DI 0 S 000
HOUR 0 000
ENG.
MODE