Lifetime 1529 - SEC 3.2 Backboard to Rim Assembly: Connecting Brackets

26
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
1/2”
AAJY
ABDY
ABFY
ABF
ABF
AAJ
ABI
ABD
ABF
ALX
*OTFSUUXP5/16” x 2 1/4” Tap Bolts (ABI) XJUIUIF5/16” Washers (ABD)BOEUIF
7/16” Rubber Washers (ABF) UISPVHIUIFCPUUPNIPMFTJOUIFCBDLPGUIFRim
(ALX)BTTIPXOBOETFDVSFUIFIBSEXBSFXJUIUXP5/16” Hex T-Nuts (AAJ)
SEC
3.3
Note: Do not overtighten the hardware so that the 7/16” Rubber
Washers bulge outward as shown.
!
Note: Make sure that the 5/16” x 2 1/4” Tap Bolts are
positioned on the outside edge of the holes as shown.
!
Correct
Incorrect
ABI
ABI
AAJ
AAJ
ALX
ABIY