Lifetime 60058 - Page 22

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
22
SEC
SEC
2.9
Place one of the Panels/Lids (BHN)ZPVESJMMFEFBSMJFSPWFSUIF&OE1BOFMTBOEBMJHOUIFIPMFTJOUIF1BOFM-JEXJUI
UIPTFJOUIF&OE1BOFMT6TJOHBOFMFDUSJDESJMMJOTFSUmWF#10 x 3/4” Phillips Pan-Head Screws (ADW) until the
IFBETPGUIF4DSFXTBSFnVTIXJUIUIF&OE1BOFMIt’s OK if the Screws (ADW) spin freely at this point. Do not worry about
stripping the plastic. Repeat this step for the other side of the Front Panel/Lid. Secure the Panel/Lid using ten (10) Plastic Nuts
(BHK), but do not overtighten.
Divots in Front/Lid Panel
Divots in End Panel
ADWY
ADW
BHN
Note: It’s OK if the Screws (ADW) spin freely at this point. Don’t worry about stripping the plastic.
!
2 ADULTS REQUIRED FOR THIS STEP
2
BHKY