Lifetime 65004 - Assembling Trailer Body and Extensions

20
4.2.1 Rotate and lower the Tongue Jack into position and chock the Wheels6HHWKH
section “Trailer Features”IRUGHWDLOVRQXVLQJWKH7RQJXH-DFN
4.2.2 Carefully lift the Rear Bed Extension (AH) off the Trailer Bed and attach to
the back of the trailer.
Hardware Needed:
´6RFNHW:UHQFK
(3)BF
(3)
BC
Hardware Bag: 1018014
4.2 Attach Rear Floor Extension
**At Least Two ADULTS Required for Assembly**
Rubber Mallet
Before beginning this step, use a Utility Knife to cut the banding around Trailer.
Utility Knife
Be careful not to damage the wiring
insulation (the colored plastic around
WKHZLUHV
AH
7RQJXH-DFN
´:UHQFK
Important:  :KLOH DQRWKHU DGXOW SUHYHQWV WKH 5HDU )ORRU ([WHQVLRQ IURP IDOOLQJ
carefully remove all loose parts from the bed of the Trailer. Inventory all parts and
hardware to ensure you received all necessary pieces. The Parts List and Hardware
,GHQWL¿HUDUHORFDWHGRQSDJHV
WARNING: Watch for pinch points as serious injury could
occur.
Rear Floor Extension