Lifetime 65004 - Page 31

31
Hardware Needed:
(3)BB
(3)
BF
Rubber Mallet
´6RFNHW:UHQFK
Hardware Bag: 1018013
4.5.66WDUWLQJDWWKHERWWRPKROHVHFXUHWKH5LJKW5HDU6LGH([WHQVLRQ3DQHOWRWKH
6LGH3DQHODQG5HDU6LGH3DQHO%UDFNHWXVLQJWKUHH3/8”-16 x 2 1/2” Hex Bolts
(BB)RQH3/8” Flat Washer (BD) DQGWKUHH3/8”-16 Nylock Nuts (BF).
Note: If necessary, after aligning the holes gently tap the Bolts with a Rubber Mallet
or Hammer to help pass them through the holes.
(1)BD
Hardware Bag: 1022647
´:UHQFK
Remember: Tighten all hardware
before proceeding to the next step,
but do not overtighten.
BB
BF
BD
4.5.7 Tighten all hardware from steps 4.2.3 - 4.5.6, but do not overtighten.
BD