Lifetime 90421 - Base Preparation; Step 1.1: Filling the Base; Step 1.2: Inserting Base Plug

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
4
OPTION A: Fill the Base (DKM) with sand.
SEC
1.1
(1)(1)
OPTION B: Fill the Base (DKM) with water. Add a tablespoon of chlorine bleach.
or
or
DKM
DKM
(35 lb)
DKM
"&'
Insert the #BTF1MVH"&' into the Base (DKM) as shown.
SEC
1.2
Note: Filling the bases with sand is recommended. Sand will provide increased performance of the
system by increasing stability and allowing for less sag in the net. Sand also reduces the chance of
leakage during storage or transport. If the base is filled with water, make sure that it remains full of
water during use. Performance will be significantly reduced if water has leaked from the system.
!