Lift Tech Marine AC - User Manual

PWC
Installation Guide
AC AND DC
1. Lower the Boat Lift and
Remove the Old Winch.
2. Remove Black Protective
Cover from the New Winch.
3. Install the Bracket and
New Winch as Shown Above.
Mounting bolts are provided if
you need them.
6. Install the Shaft into the
Spacer Collar. Make Sure the
Spacer Collar and Shaft are
Tight. Use Vise Grip if needed.
4. Install the Cable to
the Winch.
5. Install the Spacer
Collar with the Tappered
End Closest to the
Winch.
7. Install the Fiber Disc.
8. Install the Protective
Cover.
*The PWC motor shows a keyway, but we do not use it for the installation. When the
lift is going up the gear head bolt needs to be spinning clockwise. If it is not, there is a
chance the motor will loosen itself over time and spin off.
9. Install the Teardrop
Bracket onto the Back of
the Motor and Tighten.
10. Slide Motor onto the Shaft.
Install Bolt and Washer into
Teardrop and Bracket. Tighten
with Nut. Install Bolt and Washer
into Motor and Tighten.
AC Needs to be GFI Protected. Recommended extension cords up to 150
feet 12/3. You can only us one battery on the PWC DC.
WWW.LIFTTECHMARINE.COM

Summary

PWC Installation Guide

Initial Winch and Bracket Setup

Steps 1-3 cover removing the old winch and installing the new bracket and winch unit.

Cable, Collar, and Shaft Assembly

Steps 4-6 detail installing the winch cable, spacer collar, and shaft securely.

Fiber Disc and Protective Cover Installation

Steps 7-8 involve installing the fiber disc and the protective cover onto the winch.

Motor Mounting and Connection

Steps 9-10 guide the mounting of the PWC motor onto the shaft and securing connections.

Important Operational Notes

Key information on motor operation, AC GFI protection, and DC battery usage.

Lift Tech Marine AC Specifications

General

Brand	Lift Tech Marine
Model	AC
Category	Marine Equipment
Language	English