Remove it from the base and stick it on the car where you want to mount
your 12 Port Expansion Board.
Grab another Adhesive Square and peel it like the previous one. Also
stick it where you want the 12 Port Expansion Board to be.
Mount the 12 Port Expansion Board on top the Adhesive Squares.
When working on the rear lights, I found it useful to prop the car up on a
couple of small boxes which made it easier for me to access the pieces I
needed.
I will go through the steps for installing LEDs on the right hand side of the
car. When finished, repeat the same steps for the left hand side of the car.
To Next Page
Loading...
