INSTRUCTIONS 27
DIRECTIONAL
CONNECT
DISCONNECT
TURN / FLIP NOTE ICON
POWER ON TEST
TWIST / BRAIDBEND / PIVOT
LEGO
®
EIFFEL TOWER 10307 LIGHT KIT INSTALL GUIDE
NOTE
To test and use the light kit, it is
recommended to use an LMB
Power Adapter to plug in the
two USB Power Cables coming
from the set.
NOTE
To extend the USB Power
Cables, plug them into two USB
Extension Cables and then to
the Power Adapter.
NOTE
Leave the IR Switch Board plus
USB Power Cable sitting in this
area until later on.
29
If you experience any issues with the
lights not working and suspect an issue
with a component, please try a dierent
port on the expansion board to verify
where the fault lies (with the light or
expansion board). To correct any issues
with expansion board ports, please view
the section addressing expansion board
issues in our troubleshooting section.
!
!
NOTE
Connect to a 5V USB Wall
Adaptor (sold separately). A
power bank or battery pack is
not recommended to power
this set.
To Next Page
Loading...
