LIGHT4ME MINI SPOT 60 RING
Instrukcja obsługi / User Manual
7
Safety rules
Please read the user manual in detail before use. Please also keep it for future reference.
The manual contains rules for the safe use of the device.
After receiving the product, please unpack and check whether it is complete and whether
there is any damage caused by transportation. If there is damage caused by transportation,
please do not use this product and contact the dealer or manufacturer as soon as possible.
WARNING! THE DEVICE MUST NOT BE DISPOSED OF WITH HOUSEHOLD WASTE.
This symbol indicates that this product must not be disposed of with household waste, ac-
cording to the EU and your national law. In order to prevent potential damage to the environ-
ment or health, the used product must be recycled. In accordance with current legislation,
unusable electrical and electronic devices must be collected separately at the designated
facilities for recycling, acting on the basis of applicable environmental standards.
The product described in this manual comply with European directives and it is therefore CE
marked.
Keep the device away from children and unqualified persons. The manufacturer is not liable
for damage caused by improper use.
Before use, make sure the housing is not damaged and PAN & TILT movements are fully
functional. Do not connect this product to any dimming device!
Ensure a minimum distance of 0.5 m between the appliance and flammable materials. The
distance between the product and the illuminated flammable materials need to be more than
10 meters!
Disconnect the product from the power supply by pulling on the power plug – do not pull di-
rectly on the power cord! Disconnect the device from the power supply before removing the
housing or performing maintenance. If you find the power cord is damaged – do not use it!
Indoor device, use in a well-ventilated room, keep away from moisture. The distance be-
tween the device and a wall should be kept at least 50 cm. Do not expose the product to di-
rect sunlight or other lighting devices. Do not store or use the device near a fire source!
Do not look directly into the light source – the light may cause an epileptic attack in light-sen-
sitive people or people with epilepsy. Compliance with this rule is mandatory. The distance
between the eyes of the person looking at the device and the device should not be less than
4 m!
Do not install the device on a surface subjected to vibration. Do not expose the device to
high temperatures!
When the device is hanged, attach the safety rope to a suitable mounting point.
Always transport the product by holding the brackets. Do not transport the product by hol-
ding body.
In the event of a malfunction, disconnect the device from the power supply immediately!