5 OPERATION INSTRUCTIONS
∙ The moving head is for spot effect for on-site decoration purpose.
∙ Don’t turn on the fixture if it’s been through severe temperature difference like after
transportation because it might damage the light due to the environment changes. So
make sure to operate the fixture until it is in normal temperature.
∙ This light should be keep away from strong shaking during any transportation or move-
ment.
∙ Don’t pull up the light by only the head, or it might cause damages to the mechanical
parts.
∙ Don’t expose the fixture in overheat, moisture or environment with too much dust when
installing it. And don’t lay any power cables on the floor. Or it might cause electronics
shock to the people.
∙ Make sure the installation place is in good safety condition before installing the fixture.
∙ Make sure to put the safety chain and check whether the screws are screwed properly
when installing the fixture.
∙ Make sure the lens are in good condition. It’s recommended to replace the units if there
are any damages or severe scratch.
∙ Make sure the fixture is operated by qualified personnel who know the fixture before us-
ing.
∙ Keep the original packages if any second shipments is needed.
∙ Don’t try to change the fixtures without any instruction by the manufacturer or the ap-
pointed repairing agencies.
∙ It is not in warranty range if there are any malfunctions from not following the user man-
ual to operate or any illegal operation, like shock short circuit, electronic shock, lamp
broke, etc.
To Next Page
Loading...
