6 INSTALLATIONS
Cautions: For added protection mount the fixtures in areas outside walking paths, seating ar-
eas, or in areas were the fixture might be reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 items the device’s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an ap-
propriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
From a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept
at least 0.5m (1.5ft) away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety measure to prevent accidental dam-
age and/or injury in the event the clamp fails.
Mounting points: Overhead mounting requires extensive experience, including amongst oth-
ers calculating working load limits, a fine knowledge of the installation material being used,
and periodic safety inspection of all installation material and the fixture. If you lack these qual-
ifications, do not attempt the installation yourself. Improper installation can result in bodily in-
jury.
Be sure to complete all rigging and installation procedures before connecting the main power
cord to the appropriate wall outlet.
Clamp Mounting: The LED moving head provides a unique mounting bracket assembly that
integrates the bottom of the base, and the safety cable rigging point in one unit (see the illus-
tration below). When mounting this fixture to truss be sure to secure an appropriately rated
clamp to the included omega bracket using a M10 screw fitted through the center hole of the
“omega bracket”. As an added safety measure be sure to attached at least one properly rated
safety cable to the fixture using on of the safety cable rigging point integrated in the base as-
sembly.
To Next Page
Loading...
