Lightforce Striker - Fastener Torque Specifications; Important Notes

1
STRIKER LED INSTALLATION INSTRUCTIONS
DIY TWIN PACK WITH
INSTALLATION KIT CONTENTS
• 2 x Striker LED driving lights
• 2 x Spot lters
• 2 x Reversible mount and hardware
• 1 x User instructions
• 1 x DIY harness installation kit
• 1 x Driving light harness
• 1 x HB3 patch harness
• 1 x H4 patch harness
• 1 x Switch loom
• 1 x Screw for relay installation
• 4 x T-taps for wires (2 sizes)
• 4 x Spare crimps for custom wiring
• 6 x Spade terminals (2 sizes)
• 10 x Cable ties.
TOOLS AND CONSUMABLES
REQUIRED
• Spanner to access battery terminals
• Ratchet with 3 inch extension
• 17mm deep and shallow socket
• Pointy nose pliers
• Wire cutters
• Drill
• 12mm drill bit
• Phillips head driver bit
• Torch (recommended)
• Torque Wrench (recommended).
TOOLS AND CONSUMABLES
REQUIRED FOR NON-STANDARD
INSTALLATIONS
• 12mm socket
• Crimping tool.
FASTENER TORQUE
SPECIFICATIONS
M10 x 35mm bottom and side mount
bolt - 35Nm (26lb-ft).
IMPORTANT NOTES
1. Mounting points vary in design and load
capacity, ensure the weight of the light (1kg
per light with mount) is within manufacturer’s
recommended weight specications before
tment.
2. Failure to correctly mount a light may cause
damage to the light and your vehicle.
Visit lightforce.com/installations to view
instructional videos.