Need help?Do you have a question about the Lightning Audio Strike S4.1000.1D and is the answer not in the manual?
Tools and pre-installation checks for amplifier setup.
Guidance on optimal placement for cooling and performance.
Ensuring the vehicle's electrical system can handle amplifier load.
Step-by-step instructions for connecting power, ground, and signal wires.
Instructions for installing the remote level control knob.
Understanding and applying passive crossover networks for speaker frequency management.
Setting the amplifier's input gain to match the source unit's output.
Setting the crossover point for frequency band selection.
Using the subsonic filter for low-frequency cutoff on subwoofers.
Connecting two amplifiers for increased power output.
Overview of warranty periods and what the coverage includes.
Specifics on what damage or conditions are covered versus not covered.
Steps required to claim warranty service, including RA number.
Information regarding compliance with European Union warranty standards.
General| Channels | 1 |
|---|---|
| RMS Power @ 1 Ohm | 1000W |
| Signal to Noise Ratio | >90dB |
| Damping Factor | >200 |
| Input Sensitivity | 200mV - 6V |
| Low Pass Filter | 50Hz - 250Hz |
| Fuse Rating | 40A x 3 |
| Amplifier Class | D |
| Bass Boost | 0dB - 12dB @ 45Hz |
| THD at Rated Power | Less than 1% |
To Next Page
