Lights of America Motion Sensor Light Control 9700LeD User Manual (English)

Questions and Answers:

M
Michael BenderJul 30, 2025
How to fix Lights of America Motion Sensor Light Control 9700LeD when lights will not come on?
- A
  Anthony RobertsJul 30, 2025
  If your Lights of America Home Safety Product lights won't turn on, there are several possible reasons. First, ensure the light switch is on. Next, check the lamp to see if it's loose or burned out, and replace it if needed. Also, check the fuse or circuit breaker and replace the fuse or turn the breaker on if necessary. If it is daytime, the daylight turn-off feature may be active, so recheck after dark. For new installations, verify the circuit wiring is correct. Finally, make sure the sensor is aimed toward the desired coverage area.
V
Veronica HicksAug 5, 2025
Why do my Lights of America Home Safety Product lights stay on continuously?
- M
  michellelewisAug 5, 2025
  If the lights on your Lights of America Home Safety Product are staying on continuously, it could be due to a few reasons. The sensor might be picking up a heat source like an air vent, dryer vent, or a brightly painted, heat-reflective surface. In this case, reduce the range and re-aim the sensor. Alternatively, the sensor might be in Manual Override mode. To resolve this, set the control switch to 1, 5, or 10 minutes, and follow the manual override instructions to reset.
D
Darren WheelerAug 10, 2025
What to do if Lights of America Home Safety Product lights come on for no apparent reason?
- C
  cwardAug 10, 2025
  If your Lights of America Home Safety Product lights are activating for no obvious reason, consider that the light control may be sensing small animals or automobile traffic. Try reducing the range and re-aiming the sensor. It's also possible that the range is set too high, so reducing the range can help.
D
davidfreemanAug 17, 2025
Why are my Lights of America Motion Sensor Light Control 9700LeD lights flashing on and off?
- L
  Laura GrahamAug 17, 2025
  If the lights on your Lights of America Home Safety Product are flashing on and off, there are several potential causes. The heat or light from the lamps may be turning the light control on and off, so try repositioning the lamps away from the sensor. Reflected heat from other objects might also be affecting the sensor; in this case, reduce the range and re-aim the sensor. Also, the sensor could be in Test mode, where the light only stays on for 5 seconds. Finally, light may be leaking through the flood lamp reflectors; ensure that the metal lamp protectors are installed.