Lightspeed 975 - Page 2

Quick Start Guide
For complete operating instructions, go to www.lightspeed-tek.com/975-usermanual (or scan the 2D barcode).
QSUS-
PAIRING MICROPHONES TO THE 975
Your system is shipped with microphones and base units pre-paired for quick and easy use.
If you ever need to pair new components, follow this pairing process:
IR TRANSMITTER
BACK FRONT
MIC 2
POWER
MIC 1
MIC 2
MIC 1
POWER
From a powered o state, point the IR
transmitter lens toward the base unit
(for Sharemike, the transmitter lens is
located on the back of the microphone).
POINT MICROPHONES AT TOPCAT
1
Press and hold the power button for
5 seconds until the Mic 1 and Mic 2 lights
start flashing, then release the button
and let the pairing process finish.
PRESS AND HOLD POWER BUTTON
2
The status light on the 975 will light
up indicating the pairing process is
complete. The Mic 1 or Mic 2 light on
the microphone will stay illuminated.
CONFIRM STATUS
3
FLEXMIKE
SHAREMIKE
Audio
Input
Audio
Output
Audio
Output
Tone
Level
Push
StatusPower
STATUS LIGHT