Need help?Do you have a question about the LigoWave LigoDLB and is the answer not in the manual?
Details FCC compliance, warnings, cautions, and RF exposure requirements.
Covers CE Mark, R&TTE compliance, and intended/unintended EU countries for use.
Provides information and procedures for installation, setup, configuration, and management of the LigoDLB unit.
Explains typographic conventions and lists technical abbreviations used in the document.
Guides on accessing the device for the first time using default login credentials (admin/admin01).
Explains the user agreement and the importance of selecting the correct operating country for regulatory compliance.
Details the process of saving, testing, and discarding configuration changes via the web interface.
Explains the main Web management page displaying firmware, uptime, CPU load, and network status.
Displays summary of radio interface configuration, including channel, width, and power.
Provides general information about the wireless connection, SSID, and security type.
Displays network interface statistics including MAC address, Tx/Rx data, and packets.
Presents real-time traffic graphs for wired and wireless interfaces.
Shows statistics for connected wireless clients when the device operates as an Access Point.
Explains fields like Station MAC, IP address, Signal, Tx/Rx rate, CCQ, Protocol, and Link uptime.
Control device network configuration, setting operation mode to bridge or router (IPv4/IPv6).
Details settings for operating the device in Bridge mode, focusing on LAN IP settings.
Enables VLAN tagging for management traffic, restricting access by VLAN ID.
Covers IP method (Static/Dynamic), IP address, subnet mask, and gateway for IPv4.
Explains IPv6 settings like method (dynamic/static), address, prefix length, and gateway.
Introduces parameters for Router mode, including WAN, LAN, and DHCP settings.
Details manual IP address, subnet mask, default gateway, and DNS server settings for WAN.
Explains how to use DHCP client for WAN IP address acquisition.
Explains how to use DHCP client for WAN IP address acquisition.
Covers PPPoE client setup for connecting to an ISP, including username and password.
Configures LAN interface settings like IP address, subnet mask, and DHCP server.
Sets up IPv6 WAN using dynamic stateless IP, obtaining DNS from DHCPv6.
General| Brand | LigoWave |
|---|---|
| Model | LigoDLB |
| Category | Wireless Access Point |
| Language | English |
To Next Page