Liko Golvo 8000 - Service Manual

Other manuals for Liko Golvo 8000

Instruction Guide16 pages

Questions and Answers

J
Jacob MooreAug 2, 2025
What to do if Liko Medical Equipment lift cannot be operated with the hand control?
- L
  laura50Aug 2, 2025
  If the Liko Medical Equipment lift cannot be operated with the hand control, first ensure the emergency stop button hasn't been pressed. Then, check the battery capacity and verify that the charger cable is disconnected from any electric outlet. Also, confirm that the hand control cable is properly connected. If the lift functions using the operation panel, consider replacing the hand control.
D
Deborah FosterAug 7, 2025
What to do if Liko Golvo 8000 lift does not work up/down with the operation panel?
- A
  Ashley HuntAug 8, 2025
  If the Liko Medical Equipment lift does not work up or down with the operation panel, ensure the emergency stop button hasn't been pressed. Check that the cables to the control box are correctly connected and that the charger cable isn't connected to an electric outlet. Also, verify the battery capacity.
F
flynncatherineAug 12, 2025
What to do if Liko Medical Equipment cannot be controlled via the operation panel?
- O
  onunezAug 12, 2025
  If the Liko Medical Equipment lift cannot be controlled via the operation panel, ensure that the emergency stop hasn't been activated and that the charger cable isn't connected to an electric outlet. Check the battery capacity and make sure the cables to the control box are correctly connected. Also, verify that the battery’s contact plates are not defective or broken.
C
Cody GrayAug 17, 2025
What to do if Liko Medical Equipment lift cannot be controlled via HandControl IR?
- M
  Michelle HansonAug 17, 2025
  If the Liko Medical Equipment lift cannot be controlled via HandControl IR, check that the emergency stop hasn't been activated and that the charging cable isn't connected to an electric outlet. See if HandControl IR indicates a battery change is needed. If the lift has been inactive for 24 hours, enable the system by pressing the optional button on the operation panel. Ensure that the HandControl IR control is enabled.
C
Cody PayneAug 22, 2025
What to do if Liko Golvo 8000 lift is stuck in the high position?
- N
  Nancy HoweAug 22, 2025
  If the Liko Medical Equipment lift is stuck in the high position, ensure that the emergency stop hasn't been activated and check the battery capacity. Also, see if the HandControl IR indicates a battery change. Use the indicated electrical or mechanical emergency lowering to lower the patient onto a firm surface.
K
Kathleen DavisAug 27, 2025
What to do if Liko Golvo 8000 Medical Equipment lift does not reach maximum lifting height?
- J
  Jamie CarterAug 27, 2025
  If the Liko Medical Equipment lift does not reach maximum lifting height, check that the lifting interval level is correctly set.