53
Cleaning with heat
* Cleaning with heat means heating the remnants
stuck to the heater. The heater can get very hot, so
do not let anything come into contact with the heater
during or immediately after cleaning with heat.
6. Troubleshooting
I cannot insert the stick into the device.
If there are remnants from the previous stick
inside the stick insertion part, a stick may not
be inserted. Remove the remnants by pulling
the Cap out of the device and try to insert the
stick again.
Quickly press the Button
5 times (within 2 seconds).
The Status LED blinks in
orange, for 90 seconds,
and the cleaning process
proceeds automatically.
Check for any remnants
inside the stick insertion part.
If there are remnants of
a used stick, remove the
Cap from the device.
Remove the remnants
from the Cap.
When the cleaning
process ends, the Status
LED automatically goes
off, and vibration occurs
2 times.
To Next Page
Loading...
