Lillbacka Powerco FINN-POWER P32 VS User Manual

OPERATING
INSTRUCTIONS
FINN-POWER
P20 MS ¨
P20 IS/AS ¨
P20 VS ¨
P21 MS ¨
P21 IS/AS ¨
P21 VS ¨
P32 MS ¨
P32 IS/AS ¨
P32 VS ¨
P51 IS/AS ¨
P51 VS ¨
CC22 IS/AS ¨
CC22 VS ¨
MANUFACTURING YEAR ____________
RELEASED 06/00
KEEP THIS MANUAL FOR FUTURE NEEDS
THE MACHINE HAS BEEN DESIGNED FOR CRIMPING HOSE FITTINGS.
LILLBACKA POWERCO SHALL NOT BE HELD LIABLE FOR ANY
PRODUCT WHICH HAS BEEN CRIMPED ON THE MACHINE. THE
MACHINE HAS BEEN DESIGNED TO OPERATE IN ROOM
TEMPERATURE, IN DRY INDOOR CONDITIONS AND IN SUFFICIENT
ILLUMINATION. USING THE MACHINE FOR ANY OTHER PURPOSE IS
NOT ALLOWED WITHOUT WRITTEN CONSENT FROM THE FACTORY.
Lillbacka Powerco Oy
P.O.B. 1
FIN-62301 Härmä, Finland
tel. + 358 6 485 4444
fax
+ 358 6 485 4400

Lillbacka Powerco FINN-POWER P32 VS Specifications

General

Brand	Lillbacka Powerco
Model	FINN-POWER P32 VS
Category	Industrial Equipment
Language	English

Summary

GENERAL

WARNINGS

Danger Zone Identification

Identification and explanation of hazardous areas on the machine.

COMMISSIONING

Electrical Connection

Instructions for connecting the machine to the power supply.

OPERATION

Operation Modes and Controls

Mode Selector and Operation

Explanation of different operating modes and controls.

Diameter Adjustment

How to adjust the crimping diameter and retraction.

Advanced Operation Features

Test Run Procedures

Steps for performing test runs on MS/IS/AS and VS controls.

Die Set Selection

P20, P21 Models

Guide to selecting appropriate die sets for P20 and P21 models.

P32 Model

CC22 Model

Guide to selecting appropriate die sets for CC22 models.

P51 Model

Die Set Installation

Single Die Change Procedures

Setting Crimping Diameter

MS Model Adjustment Guide

Guide to setting the crimping diameter for MS models using charts.

IS/AS Model Adjustment Guide

Guide to setting the crimping diameter for IS/AS models using charts.

Diameter Setting and Limitations

VS Model Adjustment Guide

Guide to setting the crimping diameter for VS models.

Crimping Procedures

Automatic Mode Crimping

Advanced Crimping and Adjustments

Automatic Mode and Foot Pedal

Retraction Diameter Adjustment

Troubleshooting and Preventive Maintenance

Machine Not Working

Steps to take if the machine does not start or move.

Preventive Maintenance Procedures

Guidelines for routine maintenance operations.

Maintenance and Calibration

Re-calibration of Diameter Dial

Procedure to re-calibrate the crimping diameter dial for MS models.

Troubleshooting and Guarantee

Common Issues and Solutions

Common problems and their solutions.