Linak CBH Advanced

Page 16 of 32
How to pair the Bluetooth
®
Adapter and hand controls
You can pair a Bluetooth
®
hand control to the Bluetooth
®
Adapter plugged into the CBH Advanced.
Compatible hand controls are HC05BL, HC10BL, HC20BL, HC30BL and HB10BL.
Set the Bluetooth
®
Adapter in pairing mode by following the guide on the previous page. Take you hand control and press
the two upper buttons at the same time. Now the light will give a long blink and indicate that the hand control and the
Bluetooth
®
Adapter are paired up.
Hand controls with SW0077075 ver. 1.04 or newer supports dual pairing: Pairing one hand control to two CBH Advanced
using Bluetooth
®
Adapters.
How to pair
1. Connect the two CBH with Bluetooth
®
Adapter to the mains at the same time
2. The Bluetooth
®
Adapter starts to blink to indicate pairing mode has started
3. Take the hand control and press the two upper buttons and both products are paired to the hand control
How to unpair one system
1. Disconnect both CBH with Bluetooth
®
Adapters from the mains
2. Connect the CBH, on which you want to keep the pairing, to the mains
3. The Bluetooth Adapter
®
starts to blink to indicate pairing mode has started
4. Take the hand control, press the two upper buttons and give a command to move the bed. Now the pairing between the
hand control and the disconnected CBH will be deleted.