What to do if Lincoln 1400 PowerLuber fails to dispense grease?
If your Lincoln Tools PowerLuber isn't dispensing grease, first ensure that the grease tube assembly isn't empty. Refill if necessary. If the issue persists, the PowerLuber may have lost its prime, so repeat the priming operation. Another potential cause is a malfunctioning ball check (item 19). Remove item 19 to clean and inspect the ball seat area.
How to fix Lincoln 1400 Tools battery that fails to take a charge?
If the battery for your Lincoln Tools fails to take a charge, first check that the charger is properly connected to a working power receptacle. If the receptacle has power and the battery still won't charge, the battery itself may be defective and require replacement.
Why Lincoln 1400 Tools motor fails to run?
If the motor of your Lincoln Tools fails to run, the battery may need charging; in this case, recharge the battery. Alternatively, there may be faulty wiring to the motor. To address this, remove the battery, disassemble the handle, and inspect the wiring for any loose connections.
What to do if Lincoln 1400 PowerLuber continues to lose prime?
If your Lincoln Tools PowerLuber continues to lose prime, air may be trapped in the container after bulk filling. To resolve this, empty the grease tube assembly, refill it, and then repeat the priming instructions. Another possibility is that the follower may be binding in the grease tube assembly. If this is the case, replace the grease tube assembly (Item 2).
Keep work area clean, avoid explosive atmospheres, keep bystanders away.
Do not abuse cords, use specified chargers and battery packs.
Procedure to remove air from the grease tube assembly for proper operation.
Instructions on how to charge the PowerLuber battery pack.
Steps for connecting the charger and inserting the battery for charging.
To Next Page
General
