Owner/operator
responsibility
It is the owner/operator responsibility to
properly use and maintain this equipment.
The instructions and warnings contained
in this manual shall be read and understood
by the owner/operator prior to operating this
equipment.
The owner/operator shall retain this
manual for future reference to important
warnings, operating and maintenance
instructions.
Safety
The standards listed below must be
observed to prevent injury to operators and
damage to the used oil receiver.
Inspection
Prior to operation or maintenance, a visual
inspection shall be made. Check for worn
parts, air leaks, damaged, loose or missing
parts.
Check tank operation by connecting air to
air nipple and closing ball valve. Verify that
there is sufficient air flow coming from
nozzle/hose assembly.
If the unit is damaged, badly worn or
operates abnormally, it should be removed
from service. Contact a factory authorized
service center for repair.
An annual tank/component inspection is
recommended to be performed by a factory
authorized service center.
Cleaning and
maintenance
The used oil receiver does not require any
special maintenance, other than normal
cleaning, which should be done with a damp
cloth (water and alcohol or normal detergent
for household appliances made out of
plastic).
• Read all labels on the used oil receiver
carefully, do not cover them and replace
them immediately if damaged.
• The used oil receiver must only be used
by authorized personnel trained in its use.
• Never leave unit unattended when oper-
ating or evacuating.
• Never use near open flame or heat
source.
• Always disconnect air supply after
emptying.
• Never use unit for handling highly volatile
fuels and fluids.
• Use only the nozzle assembly provided.
• Pay attention to other people in the vicin-
ity while the used oil receiver is operating,
especially children.
• Do not use the used oil receiver in an en-
vironment subject to explosion hazard.
• Do not use the used oil receiver as a
means of transport.
• Do not use acid solutions which could
damage the used oil receiver and/or injure
persons.
• The used oil receiver will remain in place
up to a maximum gradient of 0.5%,
before beginning to slide.
• If the used oil receiver malfunctions, con-
tact the dealer or send it to the nearest
service center.
• When replacing parts, always demand
original replacement parts from an
authorized Lincoln dealer or retailer.
Specifications
Tank capacity 105.7 qts. (100 l)
Top of sight tube 95 qts. (90 l)
Drain bowl capacity 17 qts. (16 l)
Height at highest
position
78.5 in. (199.39 cm)
Height at lowest
position
51.25 in. (130.,8 cm)
!
Notice
This device dispenses fluid using
pressurized air, and complies with speci-
fications of Uniform Fire Code, Standard
Fire Prevention Code and National Fire
Protection Association, (NFiPA-30). It
does not comply with current provisions
of BOCA section F.5.3. Consult your local
fire marshall concerning code compli-
ance of this device.
!
Notice
Do not use cleaning solutions that
can damage plastic containers.
!
Notice
Regulator maintains pressure of
air to used oil receiver, no more than
7.5 psi (0,5 bar). Tampering with or
removing regulator will void warranty.
2
To Next Page
Loading...