*if equipped
5
2017 MKC
4
3 Service Engine Soon Light
Lights briefly when you switch on the
ignition. If it remains on or blinks after you start
the engine, the On-Board Diagnostics (OBD-II)
system has detected a problem. Drive in a
moderate fashion (avoid heavy acceleration
and deceleration) and contact your authorized
dealer as soon as possible.
4 Right Vehicle Information Display
Displays information about entertainment,
climate, phone and navigation*. Use the right,
5-way controls located on your steering wheel
to scroll, highlight and make minor adjustments
within a selected menu. Refer to the SYNC 3
chapter in your Owner’s Manual for
more information.
5 Steering Wheel Controls
Audio
Press VOL + or – to increase or decrease
volume levels. Press |⊳ or ⊲| to access the
previous or next radio station preset, CD track
or MP3 selection.
Voice
Press to answer a call.
Press
to exit phone mode or end a call.
Press
to access voice recognition.
6 Power Tilt and Telescoping
Steering Column*
The 4-way rocker control allows you to adjust
the steering wheel to the position you desire.
7 Push Button Start
Allows you to start your vehicle by pressing
the START STOP button while fully pressing
down on the brake pedal. If you leave your
vehicle idling for an extended period of
time, it automatically shuts down. Before the
engine shuts down, a message appears in
the information display, allowing the driver to
override the shutdown feature.
Note: Your intelligent access key must be inside
the vehicle for the ignition to start. The keyless
warning alert sounds the horn twice when you exit
the vehicle with the key and the vehicle is still on.
8 Push Button Shift Transmission
Your vehicle includes an electronic transmission.
The shift buttons are on the center stack next to
the SYNC® 3 system.
Putting Your Vehicle in Gear
A. Fully press down the brake pedal.
B. Press and release one of the PRNDS
buttons to select your gear.
C. The gear shift button you select lights and the
information display shows the selected gear.
D. Release the brake pedal and your
transmission remains in the selected gear.
Note: When entering an automatic car wash,
always put your vehicle into Stay in Neutral mode.
To put your vehicle in Stay in Neutral mode, make
sure your vehicle is stationary first and then:
A. Press the Neutral (N) button on the shifter
assembly once. The information display
screen then reads “Press N again to enter
Stay in Neutral mode”.
B. Press N on the shifter assembly again.
The information display displays a message
to confirm that you are in the Stay in
Neutral mode, and the N button flashes
continuously to confirm your selection.
C. To exit Stay in Neutral mode, fully press
down on the brake pedal, then press and
release another gear. Release the brake
pedal and your transmission remains in
the selected gear.
9 Auto-Start-Stop*
For more information on Auto-Start-Stop,
see page 17.
10 Auto Hold
For more information on Auto Hold,
see page 15.
11 Hazard Warning Flashers
Instrument Panel
1 Electric Parking Brake
The operating switch
replaces the conventional hand brake, and is to the left of the steering column.
To use, pull the switch. The brake system warning lamp lights to confirm that you applied the electric
parking brake. You can release the electric parking brake manually by switching the ignition on, pressing
the brake pedal and then pressing the switch down. The brake system warning lamp turns off. Refer to the
Brakes chapter of your Owner’s Manual for more details.
2 Left Vehicle Information Display
Provides information about various systems on
your vehicle. Use the left, 5-way control located
on the steering wheel to choose and confirm
settings and messages. Refer to the Information
Displays chapter in your Owner’s Manual for
more information.
To Next Page
Loading...
